This week begins with the lamination of the Limber Hole sealing part mold I made last week and then the inevitable hours and hours crouching and squatting in ...

(Ep.92) Were finally at the FINAL COUNTDOWN! We get our forestays measured up and replaced. What a workout that was! We test out our sails to ensure ...

Common issues with rotting and de-laminating bulkheads are caused from improper sealing of limber holes and standing bilge water. In an effort to eliminate ...

(Ep.91 So our mast is prepped & ready to go, so while we wait we decided to get started on lifting up the boat to get the keels inspected and prepped for ...

Here we go! Back to the boatyard to get a few more big projects done on the boat. To come is deck planking, mast raising, through-hull cutting, bottom ...

The decision to build my own blackwater tanks has opened up a lot of discussion and this week I finally get around to modifying the mould for a reduced ...

Before you build a boat, you need a good set of plans. These are brilliant! Check out Benjy's boat building plans here ➜ http://bit.ly/benjy-website 🔔 ...

Hey guys, my Catamaran plumbing plan gets the tick of approval and the work on my cabin soles becomes my focus this week including being able to "access all ...

I had a lot of fun putting this episode together. I'm looking forward to the day I get to make a sailing video for you all! We are so very grateful for the ...

Our annual Sea Kayaking Journey to Western Australia was a brilliant adventure as always as we camped, snorkeled, paddled and swam with whale sharks with a ...

If you are thinking about building a boat, we seriously need to have a chat, I put this video together to highlight the work done so far and I am not even half ...

(Ep.87) So this week we got down to buying and installing our solar panels which has been happy days for us. Now that they have been mounted.. we can hook em ...

Our final weeks of water life are upon us. Do not fret we are super excited about our haul out. In this episode we take on the sampson post and installing our ...

This week I make some templates to make the foam shaping a hell of a lot easier and the Trailer Sailor gets it's anti foul before heading back to the mooring. ...

The moral of the story is," anything that goes in the ocean is going to rust". This week's discovery gives me more than I bargained for and my boat trailer ...

The mast project took just about 2 weeks to complete. We wanted to move quickly as renting the space was adding up daily. We get the mast rounded and add the ...

This week we take you guys on a tour of our abandoned sailboat.She has been on the hard for 20 years. Are you curious? Come with us and let's go back in time ...

Last episode we laminated up a new main mast. We continue shaping the mast to fit the mast step and getting it closer to round. Long but great days working ...

We've finished up with the port side bulwark planking and now to turn our attention to Rediviva's masts... Unfortunately with all the distraction of building ...

This episode takes you through some typical work days; wake up, coffee, work on the boat, maybe a supply run, work on the boat, try not to forget to eat lunch, ...

It's time to start gluing stuff in, this week the Port Side Hull bulkheads finally find a home, not without a monumental effort of cleaning and prepping. Our ...

(Ep.77) If you would like to support our production, THANK YOU! https://www.patreon.com/svladyafrica You can also make a one time donation: PayPal: ...

When all the prep was done the reward was hanging planks! The preparations took weeks but finally the visual satisfaction of our first two runs of planking ...

(Ep.76) If you would like to support our production, THANK YOU! https://www.patreon.com/svladyafrica You can also make a one time donation: PayPal: ...