The transom is fitted and the hull is now complete from the plywood perspective. I explain the importance of learning to see with ones hands. The battle ...
Sailing Wave Rover
Gluing the hull panels together. Mrs. Rover pitches in and together we do a massive glue up on the hull. She certainly is looking like a boat now. Anybody ...
The hull sides are scribed and fitted onto the hull. Finally Wave Rover opens her cargo hold in time for Christmas with some merchandise: ...
Some of the Frames are not fitting. The problem is solved and it's time to build the transom. Builders from several countries take on the challenge of building ...
With Mrs. Rover's help the second layer of the bottom is laminated. This is a big step forward! Also, the building plans for the WR 650 are now fully complete ...
In this episode I scarf up another big panel to cover the bottom of Wave Rover. Concerning the building plans for the 650... Andy the Naval Architect needs ...
In this video I mark and cut the scarfed panels (plywood). I check a plywood scarf joint by breaking it. Then it's all hands on deck to fit and glue them so ...
I have to erect a mini vertical lofting surface to establish and develop the angle and heights for the stem (bow). And then, toward the end of the video I give ...
It's beginning to look a bit like a boat! The temporary "male plug" frames are installed on the strong back. But first the strong back has to be tweaked and ...
In this video I build a lofting "table". I then crack on with lofting and building all the frames for the Wave Rover 650. This really was easy to accomplish ...
With a near miss from Hurricane Ida, I go on a supply run to an empty lumber yard. Then it's all hands on deck (Mrs. Rover) to build the strong back for the ...
In this video, Emily makes room for the mast, waterproofs some small bits, and does a LOT of sanding as she nears the completion of her Eastport Nesting Pram ...
Emily & Clark’s Adventure (Clark’s Adventure)
Noë has joined us for 2 weeks from Pennsylvania. He worked all 14 days, even when we were ready for a break he motivated us to push. I, personally learned so ...
Salt & Tar
-Thanks for watching everyone! ~Ruthie p.s. if you’re near the SF Bay Area and would like to volunteer you can reach us here: [email protected]. Let us ...
In this video, Emily does some clear-coating, fiberglassing, and filleting to prep the seats, bulkheads, and inspection ports as she nears the sanding stage of ...
Girls can build stuff, too! Support this and other projects via our Patreon page: http://patreon.com/EmilyAndClark Over two months, Emily built a lightweight ...
An almost critical error is averted this week as the penultimate demoulding process looms after 3 years of work. Clearly demonstrates why we need to think ...
Life On The Hulls
Girls can build stuff, too! Support this and other projects via our Patreon page: http://patreon.com/EmilyAndClark During September, October, and November ...
Girls can build stuff, too! Support this and other projects via our Patreon page: http://patreon.com/EmilyAndClark Between September and November 2019, Emily ...
Big week of laminating here everyone. Batches of work are certainly the way to get ahead as I set up and lay up separate sheets to become robe and cupboard ...
Girls can build stuff, too! Support this and other projects via our Patreon page: http://patreon.com/EmilyAndClark Between September and October 2019, Emily ...
I have been dreading the laminating of the plywood bulkheads in my Catamaran since day one, and to be honest, it was a simple process with lots of prep and ...
PROBLEMS SOLVED! Chesapeake Light Craft comes to the rescue! We have worked out the issues with starting with the wrong plans. We have worked out a design ...
THE BOAT MUST GO ON! Following last week's big mistake, we decide to move forward with the basic parts of the build until we have the proper plans. In this ...