SUPPORT OUR REFIT: www.red-seas.com/refit for more information on our upcoming projects and opportunities to help out We are currently refitting our Leopard ...

18 months into a Training voyage around Japan I have some news. If you are a never-too-later like me check out the free resources at ...

I have been practicing knots and learning two new ones. The Flying Bowline is fun and can be used when need to create a loop very quickly for docking or ...

I have noticed that Wahine has been a tad slower of late and when motoring I am getting a slight shudder between 2500 - 3000 rpm. It's been a year since I ...

In this week's episode, Andre found our cutlass bearing to be bad so we get that replaced in the water, which typically requires hauling the boat out.

The sailboat refit has officially begun and that means that we have to take a lot of things apart before we can start putting it all back together again. We ...

It's been another difficult week here. Temperatures went very near to freezing..... plus it's been raining! Paint doesn't dry so well when it's cold and ...

Hello and welcome back to "Beautiful Scenic Riverside Boatyard". This week I've started and finished several projects! All new septic lines. Anchor locker ...

Hello and welcome back to the boatyard. This week I've started in on several new projects. Will it be good to get a break from sanding? Or bad to not finish ...

It's been a grueling past month of work on my boat. I've been here nearly every single day. Sanding, adding some compound or another. Then sanding and doing it ...

Good morning from the boatyard! This past week has been difficult and demoralizing. A big reason why I've not yet gotten to answering many comments and ...

Good morning everyone! Today I thought I'd put together this little video to show you the boatyard I'm repairing & refitting my sailboat at. Riverside ...

Replacing the Rudder bearing, Cutlass bearing and shaft seal on our Beneteau Oceanis 46 at the boatyard in Tunisia. We also give Sunday a good wash and polish ...

Week three and we're still grinding while we deal with those little spots of osmosis. But propeller shaft problems develop as we try to pull the cutlass ...

Removing the drive shaft (prop shaft) on SY Esper is never easy. But we begin with some spot welding of the dodger... 00:00 Spot weld with argon 00:26 Boat ...

Series of videos which covers removing the rig to replace the standing rigging and service all the rig systems, plus some other winter maintenance aspects. ...

Checking your boat hull is the first thing to do when you haul out. That includes examining the state of the anti-foul, inspecting the prop, cutlass bearing ...

SEASON 6 / The Haul Out : Episode #122 : Getting the shaft.... out Hello Friends, On this weeks episode we hire the Ventura Harbor Boat Yard to help us ...

Need to drill a big hole?... BORING! That's right, we are final to the point of boring out the stern post for our prop shaft. We were very much looking ...

Our online research suggested a hacksaw and force. . . but a fellow boater had a MUCH MORE graceful approach !! https://bumsonaboat.com ...

You answered our poll and we're delivering. This is the first of many "Casual Friday" episodes coming your way. Who's excited for more content?! Our old ...

What do you do when you find a cobra in your workshop? Our rigger isn't phased about it... watch till the end! Subscribe for more sailing videos: ...

As the haul-out travel lift came lumbering towards us, it was a lesson in hope, guts and teamwork. Subscribe for more sailing videos: ...