Watch Part 1, where we shaped the foam core in preparation for the vacuum infusion process: https://youtu.be/PLaSOuteaYQ Following on from the last video, ...
Volo
Is a boat really a boat if it can't float? Months ago we removed every thru-hull in order to replace them with new seacocks and skin fittings, but we didn't ...
This one is all about the modifications I needed to make to the deck for the new windlass. Serenity's foredeck is not cored and although the fibreglass layup ...
SEASON 6 / The Haul Out : Episode #130 : Flying the Engine and Installing the Tube Hello Friends! On this weeks episode we start out by thanking out Patrons ...
Lots of people have suggested that I should try a combination of clear epoxy and varnish on the washboards. Epoxy is very waterproof and hard-wearing, but not ...
This video covers the structural repair of a rather large crack/split/gash in the hull of Serenity. It happened two years ago just before I took her out of the ...
After sailing all the way to Rio Dulce, in Guatemala, this Hurricane damaged catamaran finally gets hauled out a year and a half after Irma, to get repaired ...
This video went on a bit longer than anticipated, but so did the install process. First a bit of an update, then a detailed look at fitting the new Forespar ...
Happy Fourth of July! In this vlog we do a lot of prep work right up until we put the first couple layers of primer on our sailboat deck. With regards to the ...
Things are still moving forward, although the year has shown less progress than I would have liked since the haul out. Still, as long as the progress is in ...
Fingers crossed. I saw a great holding tank from Tek Tanks that might just fit into some 'spare' space in the heads compartment. I made up a cardboard mock-up ...
Slightly longer video than usual. But I wanted to try and get the whole thing into one episode. I needed to remove two redundant thru-hulls, both either on or ...
Making fiberglass look smooth and shiny is no easy feat. Check out how much effort a nice surface takes to achieve.
This week it was all about the application of our Awlcraft Snow White on the decks. There was just one problem: our painter had gone AWOL, holding up the ...
With Jamie back in the UK Liz is left to oversee the refit project as well as record lots of footage for your entertainment. This week the boys start to apply ...