We head to Port Colborne, Ontario to check out two Hunter 33 sailboat's for sale. One of them was worth getting a sailboat survey done. We are blown away by ...

We add some new Raymarine i50 and i60 (wind, speed, depth) instruments to our system. These plug directly into the new SeaTalkNg backbone and eliminate the ...

Millie goes missing. The seacock installation defeats Jamie. And we need your help on the solar panel installation. Subscribe for more sailing videos: ...

Join us as we take a quick break to enjoy the party atmosphere at a food festival, before continuing our engine overhaul with a bucket of acid. We also show ...

No-one was really sure they knew what they were doing. Including the canvas guys. Can Ton come to the rescue? Subscribe for more sailing videos: ...

http://www.TheSailingFamily.com - Tavarua is on the water again and everything is fine. The indoor refit is going on and this week I did a lot of different but ...

http://www.TheSailingFamily.com - After finishing the antifouling paint a mechanic came to make a service for the motor - but you cannot believe whats happened ...

We get up early to make a long day run to Alicante, Spain. The sailing conditions were epic, and although we were close hauled for the first half, later it was ...

http://www.TheSailingFamily.com - Before we will enjoy our Endless Summer Sailing Trip we have to refit our Hallberg-Rassy 352. I started to remove the old ...

On this episode I show you guys how I went about installing my Digital Yacht GPS / AIS / VHF combo antenna for my Digital Yacht iAis receiver. I wanted to ...

http://www.TheSailingFamily.com - Yes I’m back in Panama - back at our sailboat and a lot of work is waiting for me - more than I have expected. So follow me ...

We finally tackle a finicky Fischer Panda genset that's been shutting itself down prematurely. I'm sure some viewers will see too much time spent barking up ...

Ahoy Friends! Here is another one of my project throw back videos. In this video you get to see me go through all of the steps of removing the factory Ice Box ...

We finally head east and north, across a long expanse of Mediterranean open water. It's a big passage, nothing like our short shakedown across the Strait of ...

Finally wrapping up this four part series on my head build out! In this episode I measure and drill out the deck fitting and the hole for the vent in the hole ...

On this episode I install the ports on the holding tank, get all the plumbing sorted out, install the Y valves and figure out the best way to align and find ...

We see a weather window to leave Gibraltar for Ceuta, but then get hammered on both ends.

On this episode I do a dry fit of the new holding tank I am installation on my 1965 Alberg 30. I then move on to cutting out bases for the Y-Valves and finally ...

In this video we fit 4 x 110 Ah AGM batteries to replace our boat's old house battery bank. We spent very little considering how much money we will save whilst ...

On this episode I start cutting out the old head cabinet on my 1965 Alberg 30 in preparation for installing a holding tank and re-plumbing my entire head. I ...

Crevice corrosion on keel bolts can sink a boat, so we took the decision to inspect ours. We didn't expect it to look like this... 🔔 SUBSCRIBE ➜ ...

This is more of a maintenance video, as the Hood Formula electric mainsail furler we disassembled in the previous episode is reassembled, painted, installed, ...

In this video we complete the rudder repair, hoist the sails, clean the bilges and get very close to being ready to splash! 🔔 SUBSCRIBE ➜ ...

Following our major furler failure, which damaged our sails and scared the crap out of us, the furler becomes the center of attention for a full rebuild.