Reatoring Thunder Child Preview / New Tech and Boating Gadgets At The Vancouver Boat Show!

Barry Collins steps away from refitting Thunder Child on Gabriola Island to explore electric outboards, compact watermakers, and alternator regulators at the Vancouver Boat Show.

Barry Collins and his partner Hailly faced a pressing refit schedule aboard their wooden ketch, Thunder Child, preparing the vessel for their upcoming return to living aboard. Work had recently hit an unexpected snag when a chemical mixture reacted improperly, turning a cabin wall into a gummy mess that Barry had to strip back down to bare wood before rebuilding the scratch plumbing, priming, and sanding.

With boatyard progress temporarily delayed by extensive sanding on Gabriola Island, Barry traveled across to the mainland to attend the Vancouver International Boat Show at BC Place. The trip offered a dedicated opportunity to evaluate emerging marine propulsion and off-grid electrical gear for the vessel while reporting on new technology for SailorBarry.

Ais Electric Outboard: 6.0 kW Output and Open Battery Architecture

At the indoor exhibition hall at BC Place, Barry focused his initial search on emerging electric propulsion systems. The primary target on his list was a new 6.0 kW electric outboard from the Ais model line, designed as a direct zero-emission replacement for conventional gas engines.

The representative walking Barry through the unit emphasized the system’s flexible electrical configuration: “what makes us different than everybody else in the industry on our electric outboard is that uh we are not battery specific not proprietary batteries we do not sell batteries we not battery business”. Boaters can connect existing 48V or 60V battery banks directly, avoiding expensive proprietary power packs. The motor package integrates a fly-by-wire binnacle control box and a 3-inch LCD helm display featuring built-in GPS that logs motor startup, speed, throttle position, and remaining battery state.

Mechanically, the 6.0 kW unit is equipped with standard Power Tilt and Trim, allowing skippers to trim the drive under full power to lift a dinghy’s bow and optimize speed. The complete outboard weighs 70 lb—saving 15 lb over the lightest 85 lb gas alternative—with the weight concentrated down low in the lower leg. The motor relies on passive submerged water cooling without impellers, oil reservoirs, or complex servicing points, and is offered in 15, 20, and 25-inch shaft lengths.

Low-Power Desalination: Schenker Zen 30 and Portable Case Systems

Watermaking efficiency represented the next major priority for off-grid cruising. Meeting with Steven from Eds Marine, Barry examined the 12-volt Schenker Zen 30 reverse osmosis unit. Steven highlighted the system’s exceptionally modest energy footprint: “This is our Zen 30 water maker runs off 12vt and you’re making 30 L an hour at only 9 amps”.

The Zen 30 chassis requires only 12 inches of depth and supports modular installation either upright or flat on its side. Seawater passes through a coarse through-hull intake screen to remove floating debris, flows through a 5-micron sediment cartridge, and enters the reverse osmosis membrane to yield fresh drinking water. Routine upkeep involves flushing, renewing the carbon element once per season, and replacing the sediment filter every 2 to 3 months when pressure rises, with membranes delivering 7 to 10 years of service life.

Beside the fixed installation, Steven demonstrated a 55 lb self-contained portable unit that packs the pump, filtration stages, and hoses into a transportable carrying case. Drawing 110 watts (between 8 and 9 amps at 12 volts), the portable system produces 30 liters—equating to 7.8 gallons per hour—directly from solar or generator power. Reflecting on his own tankage aboard Thunder Child, Barry evaluated the daily balance: “I’ve got 37 gallons on my boat it would take a couple hours I’d be topped up barely touch my batteries”. He observed that the compact profile makes installation feasible even on tightly packed vessels, noting that “I have spaces in my 40ft boat that that could fit and that says a lot”.

Alternator Regulation and Evening Marine Creator Collaborations

Beyond propulsion and water generation, Barry inspected the Arco Zeus Bluetooth alternator regulator. Engineered to govern high-output alternators, the unit safely delivers direct charging current to onboard lithium-ion battery banks without risking overheating or battery damage.

The boat show also served as an annual gathering for regional maritime creators participating in the BC content creator booth. Joining an evening social organized by Rob and Tia and hosted by Daryl, Barry reconnected with cruising peers. Later that night, the camaraderie turned practical on the docks when Barry joined Maya and Aladino of Sailing Magic Carpet and Simon of Finding Simon to help the crew of sailing vessel Yar troubleshoot and restart their stubborn diesel auxiliary engine.

Barry spent the night berthed aboard his friend Andrew’s vessel at Burrard Civic Marina, looking out toward the Burrard Street Bridge before preparing for another day of marine exhibits.

Granville Island Displays, Pacific Grounding Seminar, and Gabriola Refit

Navigating a 2-mile pedestrian detour along the seawall caused by nearby building construction, Barry reached the in-water portion of the boat show at Granville Island. While the floating docks were dominated by commercial yacht brokerage displays, Barry established ties with the Blue Water Cruising Association and caught up with visiting sailors from Sailing No HOA.

The centerpiece of the day was an educational presentation delivered by Ben and Ally of Breaking Waves, who detailed their harrowing experience grounding their sailboat on an inside Pacific reef after shifting anchorages. The candid discussion provided practical seamanship insights into navigating remote coral passes.

Across the water on Gabriola Island, Hailly spent her day off advancing the timber restoration aboard Thunder Child. Tackling the stubborn labor of pulling staples from foam insulation with an old screwdriver and preparing interior joinery, she confronted the arduous reality of timber maintenance: “nobody likes sanding the ceiling top sides the Top Cabin top sides”. After supporter Yan drove up from Seattle to deliver hardware components for the Colin Archer ketch, Barry completed his travel back to Gabriola Island to resume hands-on shipwright duties.

Marine SystemModel & Electrical SpecsDimensions & WeightOperational Output
**Electric Outboard**Ais 6.0 kW; 48V or 60V DC; 3-inch LCD70 lb; 15, 20, or 25-inch shaft6.0 kW output; Power Tilt and Trim; passive water cooling
**Modular Watermaker**Schenker Zen 30; 12V DC at 9 amps12-inch depth; upright or side mount30 L/h (7.8 gal/h); 5-micron filtration; 7 to 10 year membrane
**Portable Watermaker**Portable RO Unit; 110 watts (8 to 9 amps)55 lb self-contained carrying case30 L/h output from 12V solar or generator source
**Liveaboard Water Tank**SV Thunder Child freshwater system40ft Colin Archer wooden ketch37 gallons capacity replenished in approximately 5 hours

Frequently Asked Questions

What are the core technical specifications of the Ais electric outboard?

The Ais electric outboard produces 6.0 kW of electrical power, operates on non-proprietary 48-volt or 60-volt battery banks, weighs 70 lb, and includes standard Power Tilt and Trim with a 3-inch LCD helm display.

Can boaters use their own battery banks with the Ais electric motor?

Yes. The outboard does not require proprietary batteries, allowing owners to connect their own 48V or 60V banks or aftermarket lithium battery packs.

How much electricity does the Schenker Zen 30 watermaker draw?

The 12-volt Zen 30 reverse osmosis system consumes 9 amps (roughly 110 watts) while producing 30 liters (7.8 gallons) of fresh water per hour.

What is the expected operating life of the Zen 30 reverse osmosis membrane?

With proper servicing and routine pickling, the reverse osmosis membranes are expected to last between 7 and 10 years before requiring replacement.

What is the function of the Arco Zeus alternator regulator shown at the boat show?

The Arco Zeus is a Bluetooth-enabled alternator regulator designed to safely manage engine alternator output for directly charging onboard lithium-ion battery banks.

Where is SV Thunder Child being refitted by Barry and Hailly?

Barry Collins and Hailly are restoring the 40ft Colin Archer ketch Thunder Child on Gabriola Island in British Columbia, Canada.

Book a trip where this was filmed — near Vancouver

See all 57 experiences in Vancouver →

Support SailorBarry

At WeBoating.com, we profoundly acknowledge the unwavering dedication that SailorBarry invests in crafting each and every video or voyage. Their passion for delivering exceptional ocean content shines through every frame, and it's a labor of love that deserves your attention.

We invite you to watch their captivating videos here and actively engage with their content, including their social media links above. Liking, commenting, and sharing their work goes a long way in fueling their creative fire.

We're also inviting you to explore the gear, sponsorships, and boat partnerships highlighted in the "Reatoring Thunder Child Preview / New Tech and Boating Gadgets At The Vancouver Boat Show!" video description, or directly on YouTube. By engaging with these offerings or purchasing services and items, you directly support SailorBarry, their collaborators, and the brands they're associated with.

To ensure you never miss an offshore update, consider visiting their official YouTube Channel to subscribe, like, and join their community directly.

If you have any feedback, corrections, or additional information about SailorBarry or their videos, please use the comment form below to share your thoughts with us.

Thank you for being a part of our community and supporting the creators we cherish. Your time and support truly matter!

Magic Mind:
HTTPS://www.magicmind.com/sailorbarry20
SailorBarry20 gets you upto 48% off your first subscription for the next 10 days!
#magicmind #mentalperformance #selfgrowth

Finding Simon
http://www.youtube.com/@findingsimon

Sailing Magic Carpet
http://www.youtube.com/@SailingMagicCarpet

Support:
Patreon: http://www.Patreon.com/SailorBarry
PayPal: http://www.paypal.me/dustcollect
Buy Us A Beer!!: https://www.buymeacoffee.com/sailorbarry

Http://www.instagram.com/SailorBarry - Barry

Http://www.instagram.com/haillymartintattoos - Hailly

Amazon WishList!: https://www.amazon.ca/hz/wishlist/ls/2DDOVBJIOW0N0?ref_=list_d_wl_ys_list_1&filter=unpurchased&sort=default&viewType=list


#portrownsend #woodenboats #woodenboat #woodboat #boatshow #sailing #sailingadventure

Reatoring Thunder Child Preview / New Tech and Boating Gadgets At The Vancouver Boat Show! Location

  • BC Place, Vancouver, British Columbia, Canada (49.2768,-123.112)
  • Granville Island, Vancouver, British Columbia, Canada (49.2712,-123.134)
  • Burrard Civic Marina, Vancouver, British Columbia, Canada (49.2764,-123.1411)
  • Gabriola Island, British Columbia, Canada (49.1417,-123.7744)

Latest Episodes from SailorBarry

Explore the most recent voyages. Subscribe to the channel to never miss an update!

Showing 1-6 of 191 results
The Weirdest Part Of Owning A Haunted Ship
SailorBarry

The Weirdest Part Of Owning A Haunted Ship

Barry Collins sails the 1934 wooden ship Lady Hawk from Cortes Island to the Victoria Wooden Boat Show, trading kitchen shifts for pizza on Hornby Island and repairing the transom seams.
I Bought a Huge Project Boat and Sailed It Hundreds of Miles
SailorBarry

I Bought a Huge Project Boat and Sailed It Hundreds of Miles

Get an exclusive 15% discount on Saily data plans! Use code sailorbarry at checkout. Download Saily app or go to I bought a US$100,000 fishing boat that’s nearly a century old. The restoration isn’t finished, but we’re going sailing, and taking the work with us. Lady Hawk is 85 feet long and weig...
We Thought the Deadline Was Our Biggest Problem
SailorBarry

We Thought the Deadline Was Our Biggest Problem

We’re down to the wire on Lady Hawk. With only days left before we set sail, the stern still needs to come back together. In this episode we push through the final pieces of the rebuild, look ahead to three weeks under sail, but just as the deadline closes in, a fire breaks out at the marina. Read...
Rebuilding a Ship the North Sea Tried to Destroy
SailorBarry

Rebuilding a Ship the North Sea Tried to Destroy

Join the Founders Circle and become part of the story at: A shipwreck, a survival story, and sixty years of damage. As we rebuild Lady Hawk’s stern using traditional shipwrighting techniques and hand-forged tools, we uncover signs of just how much this old wooden ship has changed over time. Mean...
A 60-Year-Old Shipwreck Is Still Damaging My Boat
SailorBarry

A 60-Year-Old Shipwreck Is Still Damaging My Boat

Join the Founders Circle and become part of the story at: www.MarinerSpirit.com Two stories. One ship. Sixty years of memories that don’t quite agree. In this episode, we follow the strange history of Lady Hawk, once the Danish fishing cutter Tourup, E.502, and a North Sea disaster that may have ...
The Strange Disease Killing My 1934 Ship
SailorBarry

The Strange Disease Killing My 1934 Ship

For five months, we’ve been preparing to restore Lady Hawk without doing much restoration at all. We built the workshop, brought in the machinery, stockpiled timber, assembled the crew, and slowly developed the ability to tackle the work properly. Now, for the first time, we’re cutting into the 19...
Browse All Videos
WeBoating
Logo
Shopping cart