White oak YouTube Videos
Showing 16-25 of 25 results
Acorn to Arabella – Journey of a Wooden Boat – Episode 89: Planking Our Boat
Planking can be a long tedious process, especially when you are gluing up and fastening full length planks. We have gone into much of the details of how we are planking in previous videos, we now want to show some work being done without the interruption ...
Acorn to Arabella – Journey of a Wooden Boat – Episode 88: Setting our First Homemade Rivets!
We made our own 1/4 inch square copper rivets to hang Arabella's planks and we are now to the point where we actually get to use them! This is such an exciting time for us as we have planned and worked so hard to make these. We finally get to see the fru...
Acorn to Arabella – Journey of a Wooden Boat – Episode 87: Epoxy Tests
After our glue failure on the scarf joints for the planks, we also had some glue failure on the graving pieces. This time though, it was with a new and good batch of Resorcinol. So, we were not quite sure what the problem was at first. We later realized ...
Acorn to Arabella – Journey of a Wooden Boat – Episode 85: Glue Failure
With a project like this, there are always going to be ups and downs. The key is trying to stay up beat and finding a way around the road bumps. We've been greatly slowed down this summer by the work of figuring out the prop shaft assembly which has requi...
Acorn to Arabella – Journey of a Wooden Boat – Episode 80: Sawn Frames and Bronze Floors
In last week's episode, we went into detail about how we are fabricating the forward sawn floors. From how we are taking measurements using tick sticks and a template to how we are cutting our rolling bevel down the frames without a ship's saw. In this ep...
Acorn to Arabella – Journey of a Wooden Boat – Episode 79: Making Sawn Frames
We've done steam bent frames for the majority of Arabella, now, in the stem and the stern, it's time to make some sawn frames. Where the bow and stern come in to the centerline timbers, the shape of the hull is fairly sharp. Steam bending frames in these ...
Acorn to Arabella – Journey of a Wooden Boat – Episode 78: The Last Oak Broad Strakes
Planking has been a very fun challenge though a bit of a challenge it has been. Learning to fit the oak planks to each other has its intricacies. We need to make sure the plank fits well fore and aft but also that the bevels match so that we can put in a...
Acorn to Arabella – Journey of a Wooden Boat – Episode 74: Installing the Port side Garboard
It's on to the port side Garboard! We wanted to show a little bit more detail on what goes into installing these big planks. It can be a little bit of a fight to get them to fit just right. This one also had a little imperfection that needed to be dealt...
Acorn to Arabella – Journey of a Wooden Boat – Episode 61: Tacking Floors and Steaming Frames
We're moving right along with our silicon bronze floor timbers. We tacked most of the floor pieces together in preparation for welding them in batches. Before we can finish making the rest of the floor timbers though, we need to replace the frames that w...