Triton YouTube Videos
Showing 16-30 of 98 results
S3 #20 DIY boatwork REFLOATING… And issues.
We have finaly water under our keel and can test engine and bow thruster, but there is some small issues that we need to take care of.
The Pilot Cutter PELLEW (EP65)
Rebuilding a historic sailing yacht - The Pilot Cutter PELLEW (EP65) Support; http://www.sampsonboat.co.uk/support Become a Patron; http://www.patreon.com/sampsonboatco ----- EPISODE 65. In this episode, I return to Cornwall to catch up with Luke Powell...
S3 #19 DIY boatworkBow thruster and antifouling
The antifouling is applied and the bow thruster will ready with all the electrical... We want to refloat.!!!
S3 #18 DIY boatwork batteries to the bow thruster
We have bought batteries to the bow thruster and will start the installation. The outside hull is washed and we will prepare the antifouling-application. The new charger: https://sterling-power.com/collections/battery-to-battery-chargers/products/2015-bat...
Boatbuilding – Making Beam Shelves (Tally Ho EP62)
Rebuilding a historic sailing yacht - Making Beam Shelves / Sheer Clamps (EP62) Support; http://www.sampsonboat.co.uk/support Become a Patron; http://www.patreon.com/sampsonboatco ----- EPISODE 62. In this episode I start by adjusting the position ...
S3 #11 DIY boatwork fiberglass and cold epoxy
The temperature and weather is getting better and we can laying up fiberglass outside and then continue with our new bow thruster...
S3 #10 DIY boatwork fiberglass and a stupid mistake
We have started to close some of the holes in the bottom, but we get an challenge and could not handle the moisture on the hull due to the low outside temperature.
Installing the Fashion Pieces (Rebuilding Tally Ho EP61)
Rebuilding a historic sailing yacht – Installing the Fashion Pieces (EP61) Support; http://www.sampsonboat.co.uk/support Become a Patron; http://www.patreon.com/sampsonboatco ----- EPISODE 61. In this episode we install the Fashion Pieces, which...
S3 #8 DIY boatwork shaft and bow thruster (ENG subtitles)
There is applied filler around the thruster tunnel and the shaft is placed.
s3 #7 DIY boatwork The new bow thruster (ENG subtitles)
The parts to the engine is not arrive, so we will start mounting the bow thruster.
Sæson 3 #6 Motoren er på plads
Motoren er kommet ind på plads og vi er startet stille op på bovpropel.
Sæson 3 #5 Hul til stævnrør
Der skåret hul til stævnrøret og vi er startet på at male motorrummet.
Shaping the Keel / Adze work (EP59)
Rebuilding a historic sailing yacht – Shaping the Keel / Adze work (EP59) Support; http://sampsonboat.co.uk/support/ Become a Patron; http://www.patreon.com/sampsonboatco ----- EPISODE 59. In this episode, after roughing-out the starboard side Rabbet ...
Sæson 3 #4 Det færdige fundament
Vores fundament til den nye motor er færdig :)