Jotun YouTube Videos
Showing 1-15 of 60 results
We’ve got the Boatyard Blues! See 7 Days of our DIY Haul Out in just 20 minutes. – S2 Episode 68
The time had come. SV Our Dreamtime had not been out of the water since pre-covid days so we expected a tough week’s work when she was hauled out at Townsville’s Rosshaven Marina and that’s pretty much what we got in 32-34c heat. Having said that, we...
#73 – Insulating our PROJECT BOAT ⛵
Welcome to episode 73 of Sailing Melody Winter is coming and it's getting colder and colder here at Sailing Melody. We had to take all the old ceiling panels down last year to facilitate repairs and welding and over the summer it's been fine but with the ...
#45. – CHEAP DREAM YACHT???? RUSTY NIGHTMARE!!!!
Is Melody our cheap dream yacht or just a rusty Nightmare? The rusty steel is in a much worse condition than we thought in the cockpit this week as we continue to cut out and replace ever more steel from the aft end of Melody. We're starting to work on r...
#44 – It’s a DIRTY job but this GIRL’s gotta do it.
More Bad weather forces Melissa and Jack indoors this week so progress is made on stripping out the remainder of the cork insulation from the inside off the pilothouse and getting some lovely new epoxy paint up. Meanwhile, Andy sits around playing guitar ...
#43 – Cockpit Conundrum Part 2 – PROGRESS! NEW COCKPIT SEATS!!! – Part 2 of 2
The cockpit conundrum continues to confuse and befuddle as we move on with the build, this time tackling the aft seats. turns out the Port side seat is a fair bit narrower than the Starboard which is actually a good thing as Jack's bedroom will be on the ...
#42 – PROGRESS! NEW COCKPIT FLOOR PART 1!!!
An epic conundrum to baffle the brain and confuse the grey matter evolves as we tackle cutting out and replacing large sections of the cockpit floor/sole and seats for reconstruction. This week's episode is split into two sections with the first coming ...
#41 – Repairing a RUSTY sailboat! PREPPING AND PAINTING THE TRANSOM
Work continues on our rusty sailing yacht as we prepare and paint the inside of the transom. We've removed the whole of the inner transom skin now and have cut out and welded in a large section of replacement steel so now its time to prepare the surface ...
S3 #10 DIY boatwork fiberglass and a stupid mistake
We have started to close some of the holes in the bottom, but we get an challenge and could not handle the moisture on the hull due to the low outside temperature.
S3 #8 DIY boatwork shaft and bow thruster (ENG subtitles)
There is applied filler around the thruster tunnel and the shaft is placed.
s3 #7 DIY boatwork The new bow thruster (ENG subtitles)
The parts to the engine is not arrive, so we will start mounting the bow thruster.
Sæson 3 #6 Motoren er på plads
Motoren er kommet ind på plads og vi er startet stille op på bovpropel.
Sæson 3 #5 Hul til stævnrør
Der skåret hul til stævnrøret og vi er startet på at male motorrummet.
Sæson 3 #4 Det færdige fundament
Vores fundament til den nye motor er færdig :)
sæson 3 #3 støv og lukning af huller
Der er blevet skåret lidt mere af fundamentet og så er der blevet slebet, så det er klar til glasfiber.