Black locust YouTube Videos
Showing 1-11 of 11 results

Salt & Tar: Ep.273- Making Sawdust Again
It's been some time since we've made sawdust on board. Garrett addresses a sailing issue, maintenance, and a repair while we await his final dentist appointment and are free to set sail once again. The goal this year being southern mainland Mexico to float...
Port Side Sheer Strake – Episode 168 – Acorn to Arabella: Journey of a Wooden Boat
The weather our here in western Massachusetts has been a bit wacky. Though colder days pushed off the possibility of gluing early in the season, we're now dealing with really hot days and thunderstorms—but that's not slowing us down as we scoot along pla...
Bracing for the Sheer Plank – Episode 167 – Acorn to Arabella: Journey of a Wooden Boat
Getting the nib-ends of these full-length planks fitted into the rabbet fore and aft is one of the hardest tasks of planking Arabella. Since we don't have any wiggle room to move fore or aft, the cuts need to be dead-on for the planks to sit correctly. Add...
Mast Step and Alignment – Episode 152 – Acorn to Arabella: Journey of a Wooden Boat
With wrapping up the bronze floors comes working on the mast step. This wild looking piece is built up out of live oak and black locust and looks more like a sculpture than a structural element in the boat! We also check alignment on Arabella to see if ev...
Last Bronze Floors and a Mast Step – Episode 151 – Acorn to Arabella: Journey of a Wooden Boat
We finally get to finish up the work on the bronze floors. We had about six sets of frames that needed to go in once we removed the molds. These last sets all needed bronze floors made up for them as we couldn't make those on our first go around. That m...
Fitting the Sampson Post – Ep. 131 – Acorn to Arabella: Journey of a Wooden Boat
Steve gets back to work on the deck structure as well as fitting the sampson post. This post which lies at the bow of the vessel needs to be very strong and stick straight up out of the deck. Steve uses a couple of tricks as well as welding another bronz...
Salt & Tar: Episode 90-Turning Dead Eyes
Keeping to our salty vision we turn up our dead eyes. We are a gaff rig ketch so we couldn't very well have turnbuckles, we NEED dead eyes. This video spans over a year and two different cameras so, apologies, the sound was difficult to get right on the ep...
Acorn to Arabella – Journey of a Wooden Boat – Episode 62: Fitting the Engine Beds
We pushed really hard to get the bronze floors finished up so they could be sitting in their places during the open house. In this episode we show how we got the floors ready to start fabricating the supports for the engine beds. Since everything fits in...
Salt & Tar: Episode 49 – Breath of Fresh Air
Determined to finish Rediviva and get her sailing we've decided to focus on the projects we have the motivation for. Tired of being trapped down below working on the engine and interior it was time to step outside. Now that the sun is making more of a stea...
Acorn to Arabella – Journey of a Wooden Boat – Episode 39: Aft Deadwood and Moving Lumber
After seeing the fore deadwood and the milling in detail, we thought it would be interesting to see another side of these two processes. In this video we show how, where and why we stacked all the lumber from milling. We also get into making the Aft dead...